New Orleans Water Heater Odor Repair

Are you experiencing a dilemma with foul-smelling odors originating from the water coming from your water heater? It can happen in certain cases for a few various reasons. Here is what Water Heater Repair New Orleans suggests to do to make sure your water smells far better and to remove any terrible tastes fast.

Reasons for New Orleans Water Heater Smells?

Bacteria getting in the water system is the most frequent reason ones water in the home will have odors. If you home uses well water or cities that make use of wells for the water source, will increase the chance of this developing.

With a water heater temperature setting of 140 degrees or higher will help in reducing the development of bacteria within the water storage tank.

Exactly How to Remove Smelly Water Odors

The following directions discuss how to use chlorine bleach to clean a water heater.

The electric or gas going to the water heater tank has to first be shut off.

Next, the cold water supply off that goes to the tank needs to be shut off.

Open the hot water faucet of the kitchen area sink to enable air to get in the tank.

With a a yard hose attached to the storage tank drain valve, drain the water inside the water heater.

Then shut the drain valve as soon as it is drained.

The next step is putting in the bleach.
If the pipe for the cold water travelling within the storage tank is a flexible line, unscrew it from the tank. Otherwise, one will probably need to remove the pressure relief valve, which is more involved. For electric water heaters, one of the elements can be taken out.

Utilize a funnel to get bleach into the opening.
Pour 5 ounces of bleach for each gallon of the tank capacity.
So if you have a 50 gallon water heater, you would need 250 ounces of bleach, or about 2 gallons.

Reinstall the water line or pressure relief valve.

Fill the tank back up with water once more.

Close up the hot water faucet of the kitchen faucet as soon as all the air runs out the line.

Run all the hot water appliances till the aroma of bleach is noticeable. We want to get rid of the microorganisms that are in the water lines likewise, not only inside of the water heater.

Keep the water in the tank and water lines without using and hot water for two to three hours.

Empty the storage tank once more and refill it. This time let it remain for at least 30 minutes and yet again drain it.

Fill the tank back up. Open all the hot water fixtures and let them run until the odor of bleach is gone.

For gas water heaters, relight the water heater pilot burner. For electric water heaters, turn the power on once again.

In addition, by replacing the anode rods, or perhaps the type employed can do the trick as the following video illustrates:

Additionally, by replacing the anode rods, or perhaps the type employed can work as the next video shows:

Odors from New Orleans Water Heater

What the Experts Say

According to Soquel Creek Water District, “The smell is the result of four factors that must all be present for the odor to develop. These factors include:

  • A high concentration of sulfate in the raw water
  • Sulfate reducing bacteria, non-toxic to humans (sulfate is reduced to a sulfide state by the bacteria)
  • Little or no dissolved oxygen in the water
  • Hydrogen (a component of water which may be present due to water conditions reacting with the anode)”  Read more here…

Soquel Creek Water District

How is hydrogen sulfide gas produced in a water heater?

A water heater can provide an ideal environment for the conversion of sulfate to hydrogen sulfide gas. The water heater can produce hydrogen sulfide gas in two ways – creating a warm environment where sulfur bacteria can live, and sustaining a reaction between sulfate in the water and the water heater anode.  Read more…

Minnesota Department of Health

Check out some of our other water heater tips in our blog